🟢Contract Functions

This is the Menus that allow you to interact with your Contract. All functions relating to your Contract can be called from within Wagyu.

• Limits Settings

  • This menu will only appear if you set a Max Swap or Max Wallet during Launch Setup. It is recommended to keep this enabled until after you Enable Trading otherwise it will not apply to your launch.

    • Disable Swap Limits

      • This will disable the Swap Limits (Max Swap) that were set prior to launch.

    • Disable Holding Limits

      • This will disable the Holding Limits (Max Wallet) that were set prior to launch.

    • Disable All Limits

      • This will disable both the Holding and Swap Limits that are applied to your launch.

• Fees Settings

  • Update Fees

    • Fees cannot be changed if the contract is Renounced. Fee values cannot exceed launch values. If you launched with 20/20 buy and sell fees then those are the maximum values for their respective tax fees.

      • Buy Fee

        • The Swap Fee that is applied when users are Buying your Token. The accumulated tokens will be deposited into the Contract Address to be sold once the Fee Threshold has been reached.

      • Sell Fee

        • The Swap Fee that is applied when users are Selling your Token. The accumulated tokens will be deposited into the Contract Address to be sold once the Fee Threshold has been reached.

  • Update Fee Threshold

    • The Amount of Tokens (in percentage value) that are required to be held by the Contract Address before they will be Sold for ETH. The default value is 0.50% of the Total Supply. The Maximum Value allowed for the Swap Threshold is 2% of the Total Supply.

      • Sell Size

        • The Size of the Fee Threshold that will be followed by the Contract Address' sells. Pre-Deployment this is set in Percentage (%) Values, Post-Deployment this is set in Ethereum (ETH) Values as the token has market value.

• Ownership Settings

  • Transfer Ownership

    • Gives Ownership of the Contract to another Wallet Address. This Wallet Address will then be the only address able to call a majority of Functions on your Contract (ie. Limits Settings, Fees Settings, etc.).

      • New Owner (0x...)

        • The New Owner Address of your Contract and the one that is able to call all functions. Please ensure the information entered here is correct before proceeding.

  • Renounce Ownership

    • Gives Ownership of the Contract to the Burn Address (0x...d3ad). This is irreversible and will prevent the ability to call many of the functions that are available in your launch (ie. Limits Settings, Fees Settings, etc.).

• Safety Functions

  • Transfer Stuck ETH

    • This will Withdraw any ETH within the Contract Address to your Deployer Address and should be used in the event that your Tax Fees are not being transferred to your Deployer/Fee Address.

  • Transfer Stuck Tokens

    • This will Withdraw any Tokens within your Contract Address to your Deployer Address and should be used in the event that tokens have been sent to the Contract Address that are not the native token. It can also be used to clear token clogs if your Tax Fees are selling too slow, too much, etc.

      • Token Address

        • Enter the Contract Address of the TOKEN you are attempting to withdraw from the contract. ie. If you are withdrawing USDC from your contract input the USDC Contract Address: 0xA0b86991c6218b36c1d19D4a2e9Eb0cE3606eB48

  • Blacklist Address

    • Ban the Indicated Wallet Address from transacting with your TOKEN. WARNING: This will be flagged on Contract Scanners indicating caution when transacting with your token.

      • Address

        • The Wallet Address that you are banning from your Token.

  • Whitelist Address

    • Unban the Indicated Wallet Address from your TOKEN allowing them to interact with your token again.

      • Address

        • The Wallet Address that you are unbanning from your Token.